User manual

© 2011 Racktivity NV 26/160
Antwerpsesteenweg 19 - 9080 Lochristi - Belgium - www.racktivity.com v 2014.5.14
7. Prompt is displayed asking if you want to install a read only setup.
A read only set up is used when you want to install a blank DCPM system that will be
used for uploading back up files into the read only systems. No monitoring is performed
when installing DCPM as read only. Replications could be done to a read only system
from a live system using its backup files. All changes done in the read only setup will not
be replicated to the active system where you have downloaded the backup files from.
8. The installation will give an overview of what you selected.
Press: “Y” if the summary is correct
Installation will start.
9. Look for the IP address of your DCPM by adding the command
Ifconfig