Specifications

JOHNSON CONTROLS
2-28
FORM 102.20-N1 (1109)
Installation
V-Ray lamps (tubes) have all four contact prongs on
one end of the lamp (tube). The lamp ts into clamps
mounted in the air handler UV segment where a pre-
wired pig tail is installed. Simply engage the plug on
the pig tail with the prongs on the end of the lamp.
V-Flex lamps (tubes) t inside the opening at a slight
angle (with the pins aligned with the lamp holder).
You then “snap” the lamp base in by holding with
slight pressure the end of the lamp you have placed
inside the module with one hand and straightening up
the other end of the lamp with your other hand until
you hear the click.
FIG. 2-39 – V-RAY INSTALLATION
FIG. 2-40 – V-FLEX INSTALLATION
UVC EMITTER LIGHTS
When UV Lights are provided, the contractor is
responsible for installing UV Lamps (tubes) and
connecting a 120 volt power supply. The YORK
Solution factory provides internal wiring with a
magnetic door safety switch, a lockable disconnect
switch with “Press to Test” pilot light and a latching
circuit that has to be manually re-energized on the
air handler exterior after a door has been opened and
closed. This is all pre-wired. The UV Lamps (tubes)
are shipped loose, but in protective packaging for
installation by the contractor.
DO NOT touch UV Lamps (tubes)
with bare hands or leather gloves as
oils will damage the tubes. Use clean
cotton rags, clean jersey or latex gloves
to handle the lamps (tubes).
There three different types of lamps used in YORK
Solution Air Handlers: V-Mod, V-Ray and V-Flex.
V-Mod lamps are installed in the same manner as
standard uorescent lamps with 2 contact prongs on
each end. Engage the prongs into the slotted xtures
and rotate the lamp (tube) 90 degrees.
FIG. 2-38 – V-MOD INSTALLATION