Specifications

2-7
JOHNSON CONTROLS
FORM 102.20-N1 (1109)
2
See Fig. 2-7.
• Drill with adjustable torque.
• No. 3 Phillips bit.
• Allen wrench set.
• Nut setter - Sizes 1/4", 5/16", 3/8" and 9/16" or
socket set.
• Wire cutters.
• Power pulls or come-a-longs.
• Slings.
• Pry bar.
• Drift pins and awls.
• Common hand tools.
• Caulking gun.
Material not provided by Johnson
Controls. When unit is shipped in
sections, the gasket provided with the
curb is to be replaced with caulk pro-
vided by contractor. Gaskets on curbs
can pose a problem when sliding sec-
tions together for the nal connection
of each shipping split.

The unit base must be supported continuously, on both
sides of the unit.
UNIT INSTALLATION
Tools Needed
FIG. 2-7 – TOOLS TYPICALLY USED FOR
ASSEMBLY OF SHIPPING SPLITS
LD09613