Specifications
530.25-N1
CONTROL WI RING
(MODELS DSC300, 360)
For bottom entry ( Figure 7), the control wiring should be
routed:
CONTROL WIRING (MODEL DSC480)
For bottom entry (Figure 8), the control wlrmg should be
routed:
1. Up through the 2-1/4 inch O.D. tubing behind the con-
trol box.
2. Through the positioned ty-wrap on the outside of the
control box.
3. Through the 1-3/8 snap bushing m the control box.
4. Through the 2 ty-wraps posltmned m the control box.
1.
2.
3.
4.
Up through the tlexlble conduit and the middle deck to
the proximity of the hole into the control box.
Through the 1-3/8 snap bushing in the condenser evap-
orator partitton and control box.
Through the 2 ty-wraps positioned in the control box
Connect the wires to the printed circuit board per Fig.
9, 10 or I 1.
For side entry on slab mounted units, the control wiring
should be routed:
1, Through the 1-1/8 mch K,O. in the corner post.
2. Through the 1-3/8 snap bushing ur the condenser evap-
orator partition and control box.
3. Through the 2 ty-wraps positioned In the control box.
5. Connect the wiring to the printed clrcult board per Fig,
9, IO or 11
For side entry on slab mounted units, the control wiring
should be routed
1. Through the 1-1/8 inch K.O. in the mtermedlate post.
2. Through the 1-3/8 snap bushing m the currt ml box,
3. Through the 2 ty-wraps positioned ~n the control box
4. Connect the wires to the printed c~rcuit board per Fig.
9, [0 or 11
CAUTION
Wiringpenetration through the side entr.}’
must be sealedto preterst the entrance of’
4. Connect the wiring to the printed clrcult board per Fig,
9, 10 or 11
CAUTION: Wiringpenetration through [he side cntrj
water.
must be sealedropre~ent tile entrance of
water.
1-1/8” K O
R SIDE ENTRANCE
EXISTING
1.3/8” SNAP BUSHING
TY.WRAPS
1-3/8” SNAP BUSHING
(BY YORK)
F>
.~
‘+ -( -
W
(
21 /4” O D
Ii
TUBING
SIDE ENTRY
(BY YORK)
1
I ‘BOTTOM ENTRY
t
1
t
/ (BY YORK)
~’?
—
Ik
I!l!-.J
I
L_..–
t;
II’\
SIDE ENTRY
\
3TTOM ENTRY
---
L
FLEXIBLE
CONDUCT
(BY YORK)
1-1/8” K O
FOR SIDE ENTRANCE
FIG. 7 – CONTROL WIRING ENTRANCE (DSC300, 360)
FIG. 8 – CONTROL WIRING ENTRANCE (DSC480)
CES