Daim Ntawv Qhia Tus Neeg Siv

Waves CLA-2A User Guide

HiFreq increases voltage amplifier gain in the peak reduction circuit, for frequencies above

1 kHz, leaving lower frequencies unaffected. When set to Flat, the CLA-2A will provide equal

reduction to all frequencies. The more you move away from the Flat position, the

less sensitive

the compressor is to lower frequencies, resulting in less compression.

This control may also be

used as sort of a de-esser.

Range: 0 to 100 (in 0.1 steps)

Initial Value: 50.00

Reset Value: 100 (flat)

Analog controls analog characteristics caused by noise floor and hum, based on the power

supplies of the original units.

Range

Off, 50Hz, 60Hz

Initial Value: 60Hz

Reset Value: Off

Mix controls the balance between the compressed and the uncompressed signal.

Range: 0% to 100% (0.1% increments)

Default: 100%

Trim sets the output level of the plugin.

Range: -18 to +18 dB (in 0.1 dB steps)

Initial Value: 0

Reset Value: 0