User manual

1.Set to linked shooting mode.
Press the < > button continuously until <LINKSHOT> is
displayed on the LCD panel. Linked shooting modes Slave
unitis set.
Press the < > button again to setMaster unit of the
linked shooting mode.
2.Set the channel and ID.
3.Set the cameras shooting functions.
4.Set all the transmitters or flash.
Repeat steps 1 to 3 and set all the transmitters or flashes to
Master unit” or “Slave unit” in the linked shooting mode.
When pressing the < > button to change the setting of a
unit from ”Slave unit to Master unit,” the other transmitters (or
Sp ee d li tes ) th at w er e se t to M ast er uni t un ti l th e n
automatically switch toSlave unit.
5.Set up the slave unit cameras.
Check that the <LINK> lamp of the slave unit is lit in green.
6.Take the picture.
Check that the <LINK> lamp of the master unit is lit in green
and take the picture.
The slave unit cameras are released in coordination with the
master unit camera.
After shooting with linked shooting, the <LINK> lamp of the
slave unit is briefly lit in orange.
Linked Shooting
21