User manual

ETTL:Fully Automatic Wireless Flash Shooting
1.Set the flash as the slave unit A,
B or C . The flash will not fire if
it is set to D or E.
2.Set the same channel and ID of
the master unit and slave unit
.(p.8)
3.Position the camera and the
flash.(p.7)
4.Press the <MODE> button on
the master unit and set the
flash mode to <ETTL>.
The slave unit is set automatically
to <ETTL> during shooting via the
control from the master unit.
5.Check the transmission status
and that the flash is ready.
Check that the <LINK> lamp is lit
in green.
Check that the < > slave flash-
ready icon is lit on the master unit’s
LCD panel.
When the recycling of all the flash
units is completed, the master unit's
charge lamp lights.
6.Check the operation.
Press the master unit’s test flash
button (charge lamp). The slave unit
flashes.
7.Take the picture.
If a standard flash exposure was
o b t a i n e d , t h e f l a s h e x p o s u r e
confirmation lamp lights for 3 sec.
10