User's Manual

The Other YN-622C User Guide
14/09/2012 Page 7 of 18
First Shots
With the 622 transmitter in Remote Control mode, press [MENU] on the camera, and select Flash
Control / External flash function setting.
• The 622 transmitter will flash red and green to indicate transmitting, and the 622 Receivers
will flash green and green. They will stay in a live update state until the menu session ends.
• Select flash mode as E-TTL II mode.
• When the off-camera flash settings match the camera’s menu, the AF-assist beam of the
receiver will wink twice to show that the change is successful. If the parameter which has
been changed isn’t supported by the flash (such as hi-speed sync), this function will be
abnormal.
• Half-shutter to focus, and on the flash screen the aperture and effective range etc. will be
displayed.
• The AF-assist beam of the transmitter may assist focusing.
• Ensure that the subject is in the effective flash range, and fully press shutter button to
shoot.
• Enable the Wireless function menu to enable firing group control.
TRANSCEIVER CONTROL MODES
Remote Control Mode
• Type A camera.
• Camera menu settings take priority. Default mode. The Flash Control menus enforce
settings on flashes.
Mix Control Mode
• Type A and B cameras.
• E-TTL / Manual / Multi flash modes may be mixed.
• Flash settings take priority. Set settings manually on each flash
• By default, the 622 is in Remote Control. Change by holding down the [CH SET] button
until the channel indicator winks 3 times. Repeat to cancel Mix mode.