User's Manual

The Other YN-622C User Guide
14/09/2012 Page 18 of 18
Other problems
• Unmount all equipment, then re-mount ensuring the hot-foot is pressed fully in. .
• Replace the batteries in the 622s. Make no assumptions.
• Reset the 622s to factory default settings. (Hold [CH SET] and [GP Set] until the Status
indicator flashes red/green three times, then release.
If your camera has suitable menus, then instal the Speedlite firectkly on the camera, and
use "Clear Speedlite Settings", which reset most main and C.Fn settings.
• Install the hot-shoe flash on the camera directly and clear the custom functions of external
flash, then install it on the 622 again.
• Reset the factory settings of the camera.
SPECIFICATIONS
Standard Pack
• 2 x Transceivers, auto-switching between transmitter/controller and receiver/slave
• Quick Start Guide
• User Manual
• Some resellers may offer single or multiple units.
Transceiver Dimensions
• 90 x 53 x 25mm (39mm incl. hot-foot).
• 79gm without batteries
Electrical
• Batteries: each unit requires 2x AA batteries (1.5v Alkaline or 1.2v NiMH)
• Standby time: 60 hours.
• 6 volts maximum safe trigger voltage on hotshoe centre pin
• 300 volts maximum safe trigger voltage on PC-sync port
• Digital FSK 2.4GHz radio transceiver. Range 100m (300ft), 7 channels.
Connectors
• Hot Foot with locking ring and pin, for connecting to camera as transmitter
• Hot Shoe for mounting hotshoe flash, including on transmitter
• PC-Sync screwlock socket, sync out only (1st, 2nd, Supersync)
Controls
• Power switch Off/On
• CH Set Button 7 channels 1, 2, 3, 4 (1+2), 5 (1+3), 6 (2+3), 7 (1+2+3)
• GP Set Button group A, B, C, AB, AC, BC, ABC on Transmitter; Group A, B or C on
Receiver
• Test Button - press to awaken flash; release to fire test flash. GP changes group being
tested.
• Includes testing via PC port.
Indicators
• Status LED: Red – standby; Green operating; send/receive data.
• 3x Channel LEDs: communicating, indicating channel
• 3x Group LEDs: communicating, indicating group
Other fittings
• Red AF-Assist beam, enabled only on Transmitter. Strong cross-hatched pattern.
• Battery cover
• Eyelet for attaching a safety lanyard
Provide-your-own extras
• Batteries, safety lanyard, PC-sync cord, mini-stand, light-stand cold-shoe
All of the specification parameters are base on test conditions of Yongnuo Digital. All registered
trademarks in this user guide are the property of their respective owners. Specifications and
functions may change without notice.