Electric Skateboard User Manual Electric skateboard Read before operating the skateboard 1
Electric Skateboard Safety Warning Whenever your ride a skateboard you risk death or serious injury from loss of control, falls, road hazards, and collisions. To ride safely, you must read and follow all warnings and instructions contained in this manual. Always wear safety equipment when riding including a helmet, elbow pads, knee pads, gloves, eye protection, and abrasion resistant clothing. Do not ride in the rain, on wet surfaces, or on slippery surfaces including as steel plates or manhole covers.
Electric Skateboard Warning: Do not ride an electric skateboard at speeds or down hills where you would be unable to maintain control of a normal non-motorized skateboard. Do not touch the rear wheel, rear wheel hub or battery case immediately after use. It is HOT and may burn you or cause external injuries. Keep out of reach from children under age 8.
Electric Skateboard Packing List 1.Skateboard 2.Charger of the skateboard 3.Remote Control 4.Charge cable of the Remote Control 5.
Electric Skateboard Specifications Specification Size Weight 680*220*140mm 3.8KG Product Performance Load Max speed Up to 150 KG 18 km/h Battery Type Standard Voltage Capacity Range Lithium-ion 24V 2.2AH 8-10km Motor Power 250W Charger Input Voltage Output current Charge time AC110~240V 1.5A 3 Hours Control Model Remote 2.
Electric Skateboard Preparation Check the switch of the handle/ skateboard in place, as the diagram: REMOTE CONTROL DIAGRAM 1.Power Switch 2. MINI USB Charging Port 3.Start/Brake switch 4.Speed switch(Slow/Fast) 5.Direction switch(Forward/Backward key) 6.Backward Indicator/Charging Indicator 7.Forward Indicator 8.
Electric Skateboard PREPARATION 1. Make sure that the skateboard power switch in off state. 2. Put the switch of “slow/fast” model to “slow” mode on the handle. 3. Ensure the remote control was fully charged. 4. The Skateboard should be fully charged before first use. 5.
Electric Skateboard Operation Start : when slide “power switch”, the “Forward indicator” will be light(red indicator) Forward & Backward Mode: 1.If want move forward, push the “start/brake switch” and hold on the position, the skateboard will keep moving forward; loosen your grip, the speed will slow down, pull the back of key, it will be brake. Speed up Brake 2. Switch the driving model to “backward/charging indicator”, do the same operation as forward step.
Electric Skateboard SLOW & FAST MODE: 1. Before start the skateboard, the switch key is on the right side, it’s the “high gear” mode. 2. Switch key to right side, it will be in “slow” mode. We strongly suggest beginner keep use of beginner model. Slow High gear Battery 1. Please use the matched lithium battery. 2. Please don’t place the battery under fire, water or environment of extreme temperature. 3. Please don’t use the impacted or aging battery. 4.
Electric Skateboard Maintenance, Repair, and Disposal Inspect your electric skateboard before every ride to ensure it is in good operating condition. Do not perform any maintenance or repair on the battery case. Warning: This product contains a Lithium Ion battery that is considered a Class 9 (hazardous material) and must be handled carefully. Do not exposure to high temperature or fire. Improper disposal can result in fire or explosion.
Electric Skateboard FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Electric Skateboard radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
Electric Skateboard from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF e xposure statement.
