Product Instruction

- 10 -
2. Add lubricating oil to the walking machine
The walking machine is lubricated when it leaves the factory. But it is necessary to check the
lubricity of the treadmill frequently, which will help the treadmill to be kept in the best condition. The
treadmill must be lubricated after half a year of use or 80 hours of operation.
After every 30 hours or 30 days of use, pull the starting belt from the side and reach out to touch
the surface of the treadmill as much as possible. If you feel the silicone oil, you don’t need to add
lubricating oil; if you touch the surface, there is a strong dry feeling , Please follow the instructions
below to add lubricating oil.
Note: Please use special lubricants for treadmills or directly contact our company.
 The refueling position is on the lower surface in the middle of the running belt. (As shown below)
 Cut the mouth of the oil bottle into a small mouth, not too large, and able to inject.
 Raise the running belt so that the oil bottle is extended to the bottom of the running belt and the oil is
injected into the middle of the running board. Put down the running belt, press the oil injection part
with your hand, and rotate the running belt to spread the oil evenly on the running board.
 After turning on the machine, wait one minute for the oil to be applied evenly, and then use the
treadmill.
Note: Please turn off the power of the machine before refueling the running belt.
10. Trouble code
Code
Causes
Resolutions
E01
Poor communication
between electronic
meter and controller
1. Check that the connection between the electronic meter and the
controller is not properly connected.
2. The main IC of the controller contacts badly and is re-tightened.
3. Controller power supply abnormal, change controller
E02
Explosion-proof and
impact-proof
protection
1. If the motor is open or in bad contact, replace the motor or
check the connecting terminals.
2. Power tube breakdown, replace it or the controller.
E05
Over current
protection
1. Overload.
2. The resistance of the treadmill is too heavy and needs to be
lubricated.
3. The motor is damaged, replace it.
E06
Overload protection
E10
Keyboard and panel
control connection
communication
failure
1. Check if the connection between the electronic watch and the
controller is poorly connected.
2. The controller plug is not in good contact and is re-inserted.
3. The controller power supply is abnormal and the controller is
replaced.