Installation Manual

Table Of Contents

HIP2P IP Camera Client User Manual

第

页共

页

of presets supported by the camera.

【Preset setting】 Select the window that needs to

set the preset point, then select the preset point

number, and click the "Preset" button, then the preset

point is set successfully.

【Preset call】Select the window needed to call the preset point, then select the preset point

number, and click the "call" button. You must set the preset point before selecting the

call.

【Preset delete】 Select the window needed to delete the preset point, then select the preset

point to be deleted, and click the "Delete" button, then the preset point is deleted

successfully.

2.6. Recording management

2.6.1. Plan record

Select "Settings"-"Recording Management"-"Enable Scheduled Recording" in the tab bar as

shown above:

SUN to SAT represents a week, in days; 0 to 23 represents a day, in half an hour.

【Enable plan record】 Select the channel, and click the left mouse button to drag a green block

in the schedule table, as shown in the figure above; the range of the green

block is the time period for starting the scheduled recording. After setting the

time period, click Save.

【Close plan record】 Tick to cancel the enable plan record and click Save; or cancel the green

block in the schedule list and click Save. The method of cancel the green

block: Just click the left mouse button on the green block and drag the mouse

to cancel the green block.

Note: If the plan record time is the same for all devices, just set one device and click Copy and

Save, then all devices enabled plan record.