Installation Guide

C-3. Device Placement
Wall-mounng: hang the sensor from the wall, on a nail or screw or other secure object, using the
mounng ring
6
Surface-, Shelf- or countertop-mounng: place the sensor on a stable surface so that it will not
fall off or be knocked down
1. The sensor must NOT be submerged
2. For accurate readings, do not obstruct the openings on the sensor
3. Do not place the sensor on or near sources of extreme heat or cold
4. While this device is designed for outdoor use, refer to the environment
operang range informaon on page 17. Use of this device for
applicaons outside of the environmental operang range is likely to
damage the sensor, which is NOT covered by the warranty