Installation Guide

C-2. Add Device
Ta p “ ” b u  on , t h e n s c a n Q R
C o d e o n t h e d e v i c e . F o l l o w t h e
ste p s t o a d d t h e d e v i c e
1
1. You will need to press the SET buon once again if the device failed to connect to the cloud
2. Pressing the SET buon at any other me aer this inial process will result in the LED blinking
red/green once, only. This indicates the device is connected to the cloud and is funconing
normally
3. If the red LED does NOT blink as noted this may indicate a problem with the controller. Please
see the troubleshoong secon and the contact secon for technical support
Press the SET buon once to turn
on the device aer installaon.
The Status LED will blink red once,
t h e n g r e e n s e v e r a l  m e s ,
i n d i c a  n g y o u r d e v i c e h a s
connected to the cloud and is
ready to use
2
5
SET Buon
You must press “Bind Device” to
pair the device to your account