Installation Guide

G-3. Install or Replace the Baeries of Outdoor Alarm Controller
1. Do not press the SET buon during the enre
baery installaon or replacement process
2. Do not mix old and new baeries
With a liing /prying acon on the
two clamp latches, open the cover
on t h e controller (due to the
rainproof design, this step may be
slightly difficult)
1
I n s ta l l fo u r n e w a l ka l i n e n o n - re c h a r g e a b l e A A
b a e r i e s , a n d t h e n c l o s e t h e t wo c l a m p s o f t h e
co n t r o l l e r
2
4 x AA
Using the app, check the online
status of the controller and verify
there is no low-baery indicator
3
C o n n e c t ( o r r e c o n n e c t ) t h e
controller with t h e manipulator
(refer to pa ge 9/page 1 3)
4
30