Installation Guide

Roughly 1/2 inch
OR
U s i ng a w i re s t r i p p e r,
remove the insulaon on
each conductor, leaving
roughly half an inch of
exposed conductor
3
OR
Use a wire cuer/stripper
to remove the connector
on the new controller. Use
care to avoid cung or
nicking the antenna
2
OR
Usi n g a s c iss o rs o r u l ity
k n i f e , c a r e f u l l y r e m o v e
the o uter j acket / ins u lao n
on t he c a ble . Us e ca re t o
avo i d c u ng or n ick i ng t he
i n t e r n a l c o n d u c t o r s a n d
the a nt e nna
1
D - 3 - 1 . H o w t o P r e p a r e f o r
I n s t a l l a  o n o f t h e
C o n t r o l l e r
11
CAUTION!!
To avoid injury, use extreme care when working with cung
instruments or tools with sharp edges!