SDS
Fujian Nanping Nanfu Battery Co.,Ltd
9
7.5 Disposal
Do not dismantle batteries
Do not dispose of batteries in fire except under conditions of controlled incineration
Primary batteries may be disposed of via the communal refuse arrangements, provided that no
local rules to the contrary exist
Where there is provision for the collection of used batteries, the following should be considered:
a) Store collected batteries in a non-conductive container.
b) Store collected batteries in a well-ventilated area. Since some used batteries may still contain a
residual charge, they could be short circuited, charged or force discharged and thereby evolve
hydrogen gas. If collection containers and storage areas are not properly ventilated, hydrogen gas can
build up an explosion in the presence of an ignition source.
c) Do not mix collected batteries with other materials. Since some used batteries may still contain a
residual charge, they could be short circuited, charged or force discharged. The subsequent possible
heat generation can ignite flammable wastes such as oily rags, paper or wood and can cause a fire.
d) Consider protecting used battery terminals, particularly those batteries with high voltage, to preclude
short circuits, charging and force discharging, for instance, by means of covering battery terminals with
insulating tape.
e) Failure to observe these recommendations may result in leakage, fire, and/or explosion.
8.Instructions for use
Always select the correct size and grade of battery most suitable for the intended use. Information
provided with the equipment to assist correct battery selection should be retained for reference.
Replace all batteries of a set at the same time.
Clean the battery contacts and also those of the equipment prior to battery installation.
Ensure that the batteries all installed correctly with regard to polarity.
Remove batteries from equipment which is not to be used for an extended period of time.
Remove exhausted batteries promptly.
9.Heavy metal content
Mercury(Hg) content should be less than 1PPM
Cadmium (Cd) content should be less than 2 PPM
Lead (Pb) content should be less than 15 PPM
10.Note
Any other items do not list in here please refer to IEC 60086 standard.