User's Guide

Your YoLink products are constantly being improved,
with new features added. It is periodically necessary to
make changes to your device's firmware. For optimal
performance of your system, and to give you access to
all available features for your devices, these firmware
updates should be installed when they become available
Firmware Updates
O
In the Detail screen of each device, at the bottom, you
will see the Firmware section, as shown in the image
below. A firmware update is available for your device
if it says “#### ready now”
Tap in this area to start the update
The device will update automatically, indicating
progress by percentage complete. You may use your
device during the update, as the update is performed
“in the background”. The FEAT (feature) indicating
light will slowly blink red during the update, and the
update may continue for several minutes beyond the
light turning off
Factory Reset
P
Factory reset will erase device settings and restore it to
factory defaults. Doing a factory reset will remove the
device from your account and it will not harm the device
and will lose any data or require you to re-do your
automations, etc.
Instructions:
Hold the SET button down for 20-25 seconds until the
FEAT (feature) LED blinks red. Release the button as
soon as it blinks red, as holding the button longer than
25 seconds will abort the factory reset operation.
Factory reset will be complete when the status light
stops blinking
Only deleting a device from the app will remove it
from your account
🤔
31 32