Instruction Manual

<4. Installation>
4-1
IM 01C50E01-01EN
4. Installation
4.1 Precautions
• Before installing the transmitter, read the
cautionary notes in section 2.4, “Selecting the
Installation Location.”
• For additional information on the ambient
conditions allowed at the installation location,
refer to subsection 10 “General Specications.”
NOTE
To connect this transmitter to the Field Wireless
Network, information for connecting to the eld
wireless devices needs to be set beforehand.
Refer to subsection 6.4 “Connecting to the Field
Wireless Network.”
IMPORTANT
• When performing on-site pipe tting work
that involves welding, use care to prevent
outow of the welding current into the
transmitter.
• Do not use the transmitter as a foothold for
installation.
4.2 Mounting
• The mounting bracket shown in Figure 4.1 is
used for the transmitter and is installed on 50A
(2-inch) pipe. It can be installed either on a
horizontal pipe and a vertical pipe or on a wall.
• To install the mounting bracket on the
transmitter, torque the transmitter fastening bolt
(1) to about 20 to 30 N m.