User Manual

3-8
IM 04L21B01-17EN
Command
Name
Function Execution Mode Administrator User Page
YM Sets a transmit command of the Modbus master function (/C2 and
/C3 options)
Basic setting mode Yes No 3-44
WR Sets the instrument information output (/F1 option)
Basic setting mode Yes No 3-45
QA Sets the number of mantissa digits to display (/LG1 option)
Basic setting mode Yes No 3-46
RH Sets LogType2 (/LG1 option)
Basic setting mode Yes No 3-46
WF Sets the Modbus connection limitation (/C7 option)
Basic setting mode Yes No 3-46
WG Sets an IP address that is allowed to connect through the Modbus
interface (/C7 option)
Basic setting mode Yes No 3-46
WP Sets the phase, wiring system, and input voltage (/PWR1 option)
Basic setting mode Yes No 3-46
XE Applies basic settings
Basic setting mode Yes No 3-46
YE Applies basic settings (cold reset)
Basic setting mode Yes No 3-46
Output Commands
Note
Output commands except BO, CS, and IF cannot be placed in a command sequence.
Command
Name
Function Execution Mode Administrator User Page
Control
BO Sets the byte output order
All modes Yes Yes 3-47
CS Sets the check sum (/C2 and /C3 options)
All modes Yes Yes 3-47
IF Sets status filters
All modes Yes Yes 3-47
CB Sets the data output format
All modes Yes Yes 3-47
CC Disconnects the Ethernet connection (/C7 option)
All modes Yes Yes 3-47
Setup, measurement, and computed data output
FC Outputs screen image data
All modes Yes Yes 3-48
FE Outputs setup data
All modes Yes Yes 3-48
FD Outputs the most recent measured data and computed data Operation mode Yes Yes 3-48
FF Outputs FIFO data Operation mode Yes Yes 3-49
FL Outputs a log, alarm summary, or message summary
All modes Yes Yes 3-49
IS Outputs status information
All modes Yes Yes 3-49
FU Outputs user levels
All modes Yes Yes 3-50
FA Outputs internal FX information
All modes Yes Yes 3-50
ME Outputs data stored on the external storage medium and in
internal memory
Operation mode Yes No 3-50
MO Manages and outputs the data that has been written to internal
memory
Operation mode Yes No 3-51
RS-422A/485 commands
Esc O Opens an instrument
All modes Yes Yes 3-51
Esc C Closes an instrument
All modes Yes Yes 3-51
Common commands among instruments
*I Outputs instrument information
All modes Yes Yes 3-52
Maintenance/Test Commands (Available when using the maintenance/test
server function through Ethernet communications)
Command Name Function Administrator User Page
close Closes another device’s connection Yes No 3-52
con Outputs connection information Yes Yes 3-52
eth Outputs Ethernet statistics Yes Yes 3-53
help Outputs help Yes Yes 3-53
net Outputs network statistics Yes Yes 3-53
quit Closes the connection to the instrument that you are operating Yes Yes 3-53
Instrument Information Output Commands (Available when using the
instrument information server function through Ethernet communications)
Parameter Name Function Page
serial Outputs the serial number 3-54
host Outputs the host name 3-54
ip Outputs the IP address 3-54
3.2 List of Commands