Manual

14-24
IM 04L21B01-01EN
Communication (Serial) > Basic settings
Setup Item Selectable Range or Selections Default Value Setting
Baud rate 1200/2400/4800/9600/19200/38400 9600
Data length 7/8 8
Parity Odd/Even/None Even
Handshaking Off:Off/XON:XON/XON:RS/CS:RS Off:Off
Address Numerical value (1 to 99) 1
Protocol Normal/Modbus/Modbus-M Normal
Communication (Serial) > Modbus master > Basic settings
Setup Item Selectable Range or Selections Default Value Setting
Read cycle 1s/2s/5s/10s 1s
Timeout 125ms/250ms/500ms/1s/2s/5s/10s/1min 1s
Retrials Off/1/2/3/4/5/10/20 1
Inter-block delay Off/5ms/10ms/15ms/45ms/100ms Off
Auto recovery Off/1min/2min/5min/10min/20min/30min/1h 2min
Communication (Serial) > Modbus master > Command settings
Setup Item Selectable Range or Selections Default Value Setting
Master command number 1-8/9-16 1-8
1 to 16 Off/R-M/W/W-M Off
First Depends on the command type −
Last Depends on the command type −
Addr. Numerical value (1 to 247) 1
Regi. Numerical value (register number) 30001
Type INT16/UINT16/INT32_B/INT32_L/UINT32_B/ INT16
UINT32_L/FLOAT_B/FLOAT_L
Status relay
Setup Item Selectable Range or Selections Default Value Setting
Memory/Media status On/Off Off
Measurement error On/Off Off
Communication error On/Off Off
Memory stop On/Off Off
Power
Setup Item Selectable Range or Selections Default Value Setting
Phase and wire system 1P2W (single-phase two-wire system), 1P3W
(single-phase three-wire system), 3P3W (three-
phase three-wire system)
3P3W
Input voltage 120V/240V 240V
End
Setup Item Selectable Range or Selections Default Value Setting
Do you want to store and make the new
settings take effect?
Yes/No/Cancel −
14.2 Basic Setting Mode Menu Map and Setup Items