Manual

2-6
IM 04L21B01-64EN
Buttons for Configuring the Selected Channels at Once
Copies the settings of the first channel
Set all channels at once.
Turns all channels ON or OFF
Initializes all channels
Set all values to their minimum settable values.
Set all values to their maximum settable values.
Input Type (Mode and Range/Type)
Delta, scaling, and square root are supported for the various modes as shown below.
Mode Delta, Scaling, and Square Root
OFF DELTA SCALE SQRT LogType1 LogType2
SKIP No No No No No No
VOLT Yes Yes Yes Yes Yes Yes
TC Yes Yes Yes No No No
RTD Yes Yes Yes No No No
DI Yes Yes Yes No No No
1-5 V No No Yes No No No
The values in the Range/Type list box vary depending on the above settings.
• Span L, Span U
Input range. You cannot enter values that are outside of the range.
Note
• You cannot set the same value to [Span L] and [Span U].
• When [Delta/Scale/Sqrt/LOG Scale] is set to [Sqrt], [LogType1], or [LogType2], or [Mode] is
set to [1-5V], you can only set [Span L] to a value that is less than [Span U].
2.3 Setting the Measurement Channels