Operation Manual

7-6
IM 1F5B2-01E
7.3.2 Configuring Parameters
• The following is a typical example of the procedure for configuring a parameter. Use
this example as a reference when configuring other parameters.
• Example: Setting a Tag Number (Parameter B10)
In this example, you type the tag number as FIC-01.
B10 : TAG NO.
ABCDE
FIC - 01
A: DISPLAY
B: SET 1
C: SET 2
D: ADJUST
E: CONTROL
F: TEST
- - WELCOME - -
BRAIN TERMINAL
ID : BT200
UTEL
FEED
ON/OFF
Parameters
01 : MODEL
ULTRA YF
02 : TAG NO.
ABCDE
03 : SELF CHECK
GOOD
ENTER
OK
ADJ
ESC
Menus
ENTER
HOME
Continued at the top on
the right
Continued from the bottom on
the left
Parameters
B10 : TAG NO.
ABCDE
B20 : SIZE
25mm
B21 : PRESS RATING
L PRESS
ENTER
caps
ESC
Parameter
ENTER
ENTER
A: DISPLAY
B: SET 1
C: SET 2
D: ADJUST
E: CONTROL
F: TEST
ADJ
ESC
Menus
HOME
DIAG
ESC
DATA
PRNT
CLR
CODE
B10 : TAG NO.
ABCDE
FIC - 01
POFF
ESC
Parameter
print off
F2 : printer on
NO
B10 : TAG NO.
FIC-01
OK
Setting
NO
FEED
ENTER
Use the ⁄ key to move
the cursor to the parameter
B10: TAG NO.
Type in the desired tag
number, i.e., FIC-01.
Pressing the ENTER key once
makes the cursor begin
blinking.
Pressing the ENTER key twice
stops the cursor from blinking.
Press the key if this tag
number is acceptable.
F4
check connection
push ENTER key
Startup screen
Default Data screen
Menu screen
Menu screen
Parameter View screen
Setup screen
Setup screen
Setup screen
FEED