Operation Manual

4-13
IM 1F5B2-01E
4. MOUNTING
4.5 Swiveling the Indicator/Totalizer Component
The indicator/totalizer component can be swiveled around the neck in increments of 90°.
To change the orientation of the component, follow the procedure described below.
See Note.
See step 1.
See step 2.
Figure 4.5 Swiveling the Indicator/Totalizer
Component
(1)Loosen the setscrew at the neck of the
converter case for just one turn.
(2)Remove the four screws that join the
case and bracket and, preventing the
case from lifting off the bracket, swivel
the indicator/totalizer component so it
faces the desired direction.
(3)Reverse the operation noted in step 2
above to replace the component.
Note: To swivel the component 180°, remove
the two screws that join the body and
bracket. This strategy makes your work
easier.
CAUTION
■When swiveling the indicator/totalizer component or, in other words, the
converter case, exercise care to avoid damaging the leadwires by pulling
up on them.
■Do not swivel the converter case more than 180° in either direction.