Operation Manual

4-8

IM 1F5B2-01E

Figure 4.2-1 Gasket with Pre-cut Bolt Holes (for Four-hole Flanges)

Flange of joint pipe

Joint pipe

Figure 4.2-2 Installation of Gaskets

IMPORTANT

• Use gaskets whose inner diameter is greater than those of ULTRA YEWFLO and the

joint pipe. Exercise extreme care to prevent the gaskets from protruding into the flow

path.

■ The procedure for mounting a wafer type of ULTRA YEWFLO is the same no matter which type of

flange you use.

Horizontal Mounting

<1> Thread two collars each through each of the lower two bolts as shown in fig 4.2-

<2> Evenly fasten the nuts and bolts, tightening both edges of ULTRA YEWFLO’s

brim onto each pair of collars.

<3> Make sure the process fluid is not leaking.