Manual

1-170

IM 04L51B01-01EN

1.24.2 Reconfiguring the GX/GP

When you reconfigure the GX/GP, the installed I/O modules are detected, and the settings

are changed accordingly.

Reconfiguration is necessary in the following situations.

• When you install a newly purchased module

• When you change the modules (change to different modules)

• When you add or remove modules

If you purchased a I/O module preinstalled option (/U□□0 or /CR□□0), there is no need to

reconfigure if you are going to use the GX/GP as-is.

However, if you change modules, add modules, or delete modules, you will need to

reconfigure.

Path

GX/GP: MENU key > Browse tab > Initialize Calibration > Menu Reconfiguration

Procedure

Tap Execute.

The system information appears.

Switches the display

X X XXXXXXX

XX-XX-XX-XX-XX-XX

RX.XX.XX

Tap Restructure.

A conrmation screen is displayed.

Tap OK.

The GX/GP will recongure.

Operation complete

Note

• Do not carry out the following operations while the GX/GP is reconfiguring. Doing so may cause

damage.

Turn the power off and on.

Insert or remove modules.

• If the total number of I/O channels of the installed modules exceeds 100 (GX20/GP20) or 48

(GX10/GP10) , no additional modules can be reconfigured.

1.24.3 Adjusting the Touch Screen

See page 5-6 in section 5.1.4, “Adjusting and Checking the Touch Screen”.

1.24 Initializing and Calibrating the System (Initialization, reconfiguration, touch screen calibration)