Manual

28
IM 04L51B01-02EN
Reconfiguring the GX/GP (Module identification)
Reconfiguring the GX/GP
When you reconfigure the GX/GP, the installed I/O
modules are detected, and the settings are changed
accordingly.
Reconfiguration is necessary in the following situations.
• If you specify modules separately
• If you change the modules (change to different
modules)
• If you add or remove modules
If you purchased a model with preinstalled modules (/U[]
[]0 or /CR[][] option), you can start using the GX/GP right
away without any reconfiguration. However, if you change
modules, add modules, or delete modules, you will need
to reconfigure.
1 Press MENU.
2 Tap the Browse tab.
3 Tap Initialize Calibration.
4 Tap Reconfiguration.
5 Tap Execute.
The system information appears.
XX-XX-XX-XX-X X - X X
RX.XX.XX
XXXXXXXXX
6
RX.XX.XX
6 Tap Reconfigure.
7 Tap OK.
Operation complete
Note
Do not carry out the following operations while the GX/
GP is reconfiguring.
• Turn the power off and on
• Insert or remove modules
This section explains what you need to do when you change the module configuration (by installing or removing modules).
Initializing the GX/GP
(Initializing all settings)
Initialize the GX/GP after reconfiguring the GX/GP when
channels are not assigned to display groups. Channels
are automatically assigned during initialization.
For details, see the User’s Manual (IM 04L51B01-01EN).
Note
• This procedure is not necessary if you purchased an
I/O module preinstalled model and do not need to
change the configuration.
• If you initialize, setting parameters are reset to their
factory defaults. We recommend that you back up
setting parameters before initialization.
1 Press MENU.
2 Tap the Browse tab.
3 Tap Initialize Calibration.
4 Tap Initialize all > On.
4
5
5 Tap Execute.
A conrmation screen is displayed.
6 Tap OK.
The settings are initialized.
Operation complete