Instruction Manual

3-65
IM MW100-01E
Setting and Data acquisition
1
2
3
4
5
App
Index
File selection screen
Selects the report file to be displayed in the graph.
Click the OK button to return to the Report - Graph screen.
Channel selection screen
Selects the channels and tag names displayed in the graph.
Up to 10 channels can be selected. You can clear all selections with Clear All button
(Firmware version R3.02 or later).
Click the OK button to return to the Report - Graph screen.
Setting Mode
Display Settings
Tag Settings
Enter Tag names to assign to measurement and MATH channels. If the tag name display
is enabled, the tag names specified here are displayed.
For the procedure to switch to the tag name display, see “Other Settings” in this section.
1.
From the top screen, click Display Setting > Channel Tag Setting.
2.
Select the tag number group you wish to set from the Channel List list.
3.
Enter a tag name in the Tag box of each tag number.
You can use 15 alphanumeric characters. If you do not enter the tag names, the channel
numbers are displayed even if the tag name display is enabled.
4.
Click the Apply button. The setting changes take effect.
3.16 Measured Data Monitor Display/Settings