Instruction Manual

3-17
IM MW100-01E
Setting and Data acquisition
1
2
3
4
5
App
Index
Executing Strain Initial Balancing
1.
Select the initial balance execution method from the Strain Initial Balancing list.
2.
Click the Apply button. Initial balancing is executed on the channel selected in the
strain input settings in the channel settings.
For channel settings when executing strain input initial balance, see “Setting Up and
Executing Strain Input Initial Balancing” in section 3.5.
Status Information and Processing/Operation
You can change the MW100 operation mode, operate the main unit keys, and check
alarm statuses. The operation described here can also be carried out in measurement
mode.
Changing Status Information (Mode)
From the top screen, click System Setting > Status Information. You can perform the
same procedure in the Status table in the top screen.
• Switching between Measurement Mode and Setting Mode
1
In the Operation box under Measurement, you can select Start to switch to
Measurement mode, or Stop to switch to Setting mode.
2.
Click the Apply button. The changed status is displayed in the Status display
box.
• Computation Start/Stop
1
In the Operation box under the MATH item, you can select Start to start
computation, or Stop to stop computation.
2.
Click the Apply button. The changed status is displayed in the Status display
box. You can also start and stop computation from the Monitor screen.
• Recording Start/Stop
1
In the Operation box under the Recording item, you can select Start to start
recording, or Stop to stop recording.
2.
Click the Apply button. The changed status is displayed in the Status display
box. You can also start and stop recording from the Monitor screen.
Checking Status Information
When an alarm occurs, Waiting Alarm ACK is displayed in each display box.
3.3 System Settings