Instruction Manual

IM 11M12A01-03E
7-11
7. Startup
Enter
Primary value:
Humidity
r Secondary value:
mA-output1
r Tertiary value:
mA-output2
r Tag name:
Display item
F7.14.EPS
Primary value:
Oxygen
r Secondary value:
mA-output1
r Tertiary value:
mA-output2
r Tag name:
Enter
Oxygen
Humidity
Mixing
Item of output1 damping
Item of output2 damping
Display item
F7.15.EPS
Figure 7.14 Display Item Display Figure 7.15 Display Item Selection
Table 7.2 Display Items
Item Primary Secondary and Display
value tertiary values
Oxygen concentration Oxygen concentration during measurement
Humidity Humidity (%H
2
O) in the exhaust gas
Mixing ratio Mixing ratio during measurement
Relative humidity Relative humidity calculated from the measured value
Dew point Dew point calculated from the measured value
Output 1 item Oxygen concentration with the equipment set for oxygen analyzer
(See *1 below.)
Output 2 item Oxygen concentration with the equipment set for oxygen analyzer
(See *1 below.)
Current output 1 Current value output from analog output 1
Current output 2 Current value output from analog output 2
*1 : If an analog output damping constant is set, display data then includes these settings.
T7.2E.EPS
s
s
s
s
s
s
s
s
s
s
s
s
s
s
Tip
For the relative humidity and dew-point calculations, appropriate operation parameters
should be entered. For details on the parameters, consult Section 8.6.3, “Setting
Measurement Gas Temperature and Pressure,” later in this manual.