Instruction Manual
5-2
IM 01R04B04-00E-E 8th edition March 01, 2011 -00
All Rights Reserved. Copyright © 2003, Rota Yokogawa
4 line indication
3 line indication
2 line indication.
1 line indication
+123.450 kg/h
+12.3400 deg
0.99700 kg/l
+12.3450 kg
MFR
TMP
DEN
FTL
+123.450
kg/h
MFR
+123.450
kg/h
+12.3400
degC
MFR
TMP
+123.450
kg/h
+ 12.3400 degC
0.99700 kg/l
l
MFR
TMP
DEN
F53.EPS
The infrared switches operate as ON status by detecting the infrared ray reection from a nger put over
the switches through the glass plate of the cover. Switches are just below the printed letters SET, SHIFT,
on the faceplate.
When you touch the switches, please note the following :
The switches may operate even when you do not touch the glass plate, if your ngers come near the
glass plate, so please touch the switches sliding with your nger from the lower part of the glass plate.
Also be sure not to touch more than one switch at one time by covering your other ngers over the
faceplate, unless you would like to push “SHIFT+SET” or "SHIFT+ .
You can increase the sensitivity of the infrared switches by sticking a white piece of tape on your nger tip.
Setting via the infrared buttons can be blocked via the HART protocol. If HART protocol is not used the
infrared buttons can be blocked by a black tape glued behind the window.
NOTE