Instruction Manual



3-10

IM 01R04B04-00E-E 8th edition March 01, 2011 -00



1 Model code

2 Serial number

3 Calibration constants of detector (see also on calibration certicate)

4 Number of notied body according ATEX (only for ATEX certied owmeters)

5 Number of notied body according PED (only for units with process connections greater than DN25)

6 Area for Ex- relevant marking (see chapter 9). The CE-mark is not present for FM-approved units.

7 PS = maximum permissible pressure

8 TS = maximum permissible process temperature

9 Material of metering tubes

10 Year of manufacturing

11 Customer specied tag number if option /BG was ordered



In general the name plates of these units are the same as shown above.

The difference is as followed:

PS is named as "Working pressure range"

TS is named as "Process temperature range"

"Dual Seal" is additionally stated on the name plate