Instruction Manual


7-94
IM 01R04B04-00E-E 8th edition March 01, 2011 -00
All Rights Reserved. Copyright © 2003, Rota Yokogawa
Detailed information about using the pulse and status output see chapter 7.12.
 Select: 






If  is selected, status output becomes active for forward
ow and not active for reverse ow, if parameter  set to
. It is the other way round, if parameter  is set to
 (see 7.17).
If  is selected, status output becomes active, when
the totalizer reaches the value set to parameter  (see
7.17).
If an alarm function is selected, status output becomes active, if the
concerning alarm occurs.
If  is selected, status output becomes active, if at least one
alarm occurs. The same applies for errors with the setting All errors.
For  the status output becomes active, if at least
one alarm or one error occurs.
 Select: 
The output levels depending on this parameter are shown on page 7-91.

 To set the .
 Select: 


If  is selected, active status input starts autozero procedure.
If parameter  is enabled:
- If  is selected, active status input sets 
 to zero.
- If  is selected, active status input sets mass
totalizer to zero.
- If  is selected, active status input sets
volume totalizer to zero.
- If  is selected, active status input sets
net totalizer to zero.
- If  is selected, active status input sets all
totalizer to zero.
 Select: 
If  is selected, the status input is closed active.
If  is selected, the status input is open active.