User guide

2-3
IM 04L41B01-04E
Advanced Settings of Screen and Component
1
2
3
App
Index
Visible
You can choose to show or hide the components on the execution screen.
 On:Showcomponentsontheexecutionscreenandbuilderscreen.
 Off:Hidecomponentsontheexecutionscreen.Componentswillbevisibleonthe
builder screen.
You will not be able to change this setting if a component is depending on other
components.
Group control
Youcanconguresettingsofdisplaygroupcontrolstatus.
Setting range
You can select [None], [GR. CTRL 1], [GR. CTRL 2], [GR. CTR
L 3], or [GR. CTRL4].
 Youcanalsoconguregroupcontrolsettingsusingthesoftkey.Seesection1.11or
appendix 1 for more information about group control.
Gr.Ctrl order (Group control order)
You can configure the group control order. This setting is available when you set anything
except [None] for the group control.
Setting range
DX1000 = 1 to 6, DX2000 = 1 to 10
 Youcanalsoconguregroupcontrolsettingsusingthesoftkey.Seesection1.11for
more information about group control.
Sync act (Synchronize action)
You can change the show/hide settings of components on the execution screen by
synchronizingOn/Offsettingsofalarmorinternalswitch.Youcanalsoenlargethe
display of trend components and scale components to an arbitrary span by configuring
the 2nd span.
Depend ID configured will invalidate the visible setting at the synchro attribute field.
Synchro target: Alarm
Synchro target: Switch
Attribute Description Default value
Synchro attribute Configure the attribute you want to synchronize.
You can select None, Visible, or 2nd span. 2nd span is
available for trend components and scale components
only.
None
Value (switch On) Configure the synchro attribute value when the synchro
target(alarm
orswitch)issettoOn.SelectOnorOff.
On
Synchro target Configure the target you want to synchronize.
Select alarm or switch.
Alarm
Channel no
or
Switch no
Configure channel number or internal switch number
you want to synchronize. If the synchro target is an
alarm, enter a channel number. If it is a switch, select
an internal switch number.
1
Alarm level Configure the alarm level you want to synchronize.
Select any or all of the following setting range: 1, 2, 3, 4.
1
2.2 Common Attributes of Components