Owner manual

1-80
IM 04L41B01-17E
DX Settings (KDC server to connect to and authentication key)
◊ Press MENU (to switch to setting mode), hold down FUNC for 3 s (to switch to basic
setting mode), and select the Menu tab > Communication(Ethernet) > Password
management > KDC connection, Certification key.
KDC connection
Certification key
KDC Connection
You can specify a primary and a secondary KDC server.
• KDC server name
Enter the KDC server name here using up to 64 alphanumeric characters.
• Port number
You can specify a value from 1 to 65535. If you do not specify a port number, the
default port number, which is 88, is used.
Certification Key
• Host principal
The DX account name registered on the KDC server. You can enter up to 20
alphanumeric characters.
*1
*1 You cannot use forward slashes or at signs.
• Realm name
The name of the domain that contains the KDC server and the DX. You can enter up
to 64 alphanumeric characters.
*2
*2 You cannot use forward slashes or at signs. Characters are case-sensitive.
• Password
Set the password to use to access the KDC server using up to 20 characters. The
password is displayed as “**********.”
• Encryption Method
Select an encryption method that the server supports from AES128, AES256, and
ARC4. ARC4 (ARCFOUR) is an encryption algorithm that is compatible with RC4.
Note
• The host principal is converted within the DX as shown below.
host/(host principal)@(realm name)
• Cross-realm authentication (authentication of different domain names) is not supported.
1.14 Using the Password Management Function (/AS1 option)