Owner manual

3-16
IM 04L41B01-17E
3.3 Setup Parameters
The measurement range and setup range of parameters used in a command vary
depending on the combination of the command, range, and options.
Parameter Input Example of Measurement Range
The span upper and lower limit parameters of the SR command (input range setting
command) requires all digits including those to the right of the decimal to be entered.
For example, if you want to set the upper limit to 1.0000 V when the measurement range
is -2.0000 V to 2.0000 V, the value is 10000. If you want to set the limit to 0.5000 V, the
value is 5000.
The table below gives configuration examples.
Measurement
Range
Input Type
Parameter
Selectable Range of the
Measurement Range
Specified Range Parameter
VOLT
20mV -20.000mV
to
20.000mV -10.000mV
to
20.000mV -10000
to
20000
/SQRT 2V -2.0000V
to
2.0000V -2.0000V
to
0.5000V -20000
to
5000
TC R 0.0
to
1760.0 0.0
to
400.0 0
to
4000
K -200.0
to
1370.0
-200.0
to
1370.0 -2000
to
13700
RTD Pt100 -200.0
to
600.0 -10.0
to
500.0 -100
to
5000
DI LEVEL 0
to
1 0
to
1 0
to
1