Owner manual

3-15
IM 04L41B01-17E
Commands
1
2
3
4
5
6
App
Index
Command
Name
Function Execution
Mode
Setting Connection Monitor
Connection
Page
WI Sets the relay operations B Yes No No 3-58
WF Sets the Modbus connection limitation B Yes No No 3-58
WG Sets an IP address that is allowed to connect via
Modbus
B Yes No No 3-59
WJ Sets the FTP transfer wait time B Yes No No 3-59
WQ Sets PROFIBUS-DP B Yes No No 3-59
YE Activates basic settings (cold reset) Bb Yes No No 3-59
Output Commands (/AS1)
Note
Output commands except BO, CS, and IF cannot be placed in a command sequence.
Command
Name
Function Execution
Mode
Setting Connection Monitor
Connection
Page
Administrator User
Control
BO Sets the byte output order ALL Yes Yes Yes 3-60
CS Sets the check sum (can only be used during serial
communication)
ALL Yes Yes Yes 3-60
IF Sets status filters ALL Yes Yes Yes 3-60
CB Sets the data output format ALL Yes Yes Yes 3-60
CC Disconnects the Ethernet connection (can only be
used for Ethernet communications)
ALL Yes Yes Yes 3-60
Setup, measurement, and computed data output
FC Outputs screen image data ALL Yes Yes Yes 3-61
FE Outputs setup data ALL Yes Yes Yes 3-61
FD Outputs the most recent measured and computed data OSsb Yes Yes Yes 3-61
FF Outputs FIFO data OSsb Yes Yes Yes 3-61
FL Outputs a log, alarm summary, or message summary ALL Yes Yes Yes 3-62
FI Outputs an operation log ALL Yes Yes Yes 3-62
IS Outputs status information ALL Yes Yes Yes 3-62
FU Outputs user levels ALL Yes Yes Yes 3-63
FA Outputs internal DX information ALL Yes Yes Yes 3-63
ME Outputs data stored on the external storage medium
and internal memory
OSsb Yes No No 3-63
MO Manages and outputs the data stored in the internal
memory
OSsb Yes No No 3-63
Dedicated commands for RS-422/485
Esc O Opens an instrument ALL Yes Yes Yes 3-64
Esc C Closes an instrument ALL Yes Yes Yes 3-64
Common commands among instruments
*I Outputs instrument information ALL Yes Yes Yes 3-65
Maintenance/Test Commands (Available when using the maintenance/test
server function via Ethernet communications)
The administrator is “admin.” The user is “user.”
Command Name Function Administrator User Page
close Closes another device’s connection No No 3-65
con Outputs connection information Yes Yes 3-65
eth Outputs Ethernet statistics Yes Yes 3-65
help Outputs help Yes Yes 3-66
net Outputs network statistics Yes Yes 3-66
quit Closes the connection to the instrument that you are operating Yes Yes 3-66
Instrument Information Output Commands (Available when using the
instrument information server function via Ethernet communications)
Parameter Function Page
serial Outputs the serial number 3-67
host Outputs the host name 3-67
ip Outputs the IP address 3-67
3.2 A List of Commands