Owner manual

3-8
IM 04L41B01-17E
Group Command Function Execution Administrator User Page
Name Mode
Setting (continued)
YL
Sets the operation of the Modbus master function
Basic setting mode Y
es No 3-57
YM
S
et
s a transmit command of the Modbus master function Basic setting mode Yes No 3-57
WR
Sets the instrument information output
Basic setting mode Y
es No 3-58
WI
Sets the relay operation
Basic setting mode Y
es No 3-58
WF
Sets the Modbus connection limitation
Basic setting mode Y
es No 3-58
WG
Sets an IP
address that is allowed to connect via Basic setting mode
Yes No 3-59
Modbus
WJ
Sets the FTP
transfer wait time Basic setting mode
Yes No 3-59
WQ
Sets PROFIBUS-DP Basic setting mode
Yes
No 3-59
XE
Activates basic settings
Basic setting mode Y
es No 3-59
YE
Activates basic settings (cold reset)
Basic setting mode Y
es No 3-59
Output Commands
Note
Output commands except
BO
,
CS
, and
IF
cannot be placed in a command sequence.
Group Command Function Execution Administrator User Page
Name Mode
Control
BO
Sets the byte output order
All modes Y
es Yes 3-60
CS
Sets the check sum (can only be used during serial
All modes Y
es Yes 3-60
communications)
IF
Sets status filters All modes Y
es Yes 3-60
CB
Sets the data output format All modes Yes Yes 3-60
CC
Disconnects the Ethernet connection
All modes Y
es Yes 3-60
(can only be used for Ethernet communications)
Setup, measurement, and control data output
FC
Outputs screen image data
All modes Y
es Yes 3-61
FE
Outputs setup data
All modes Y
es Yes 3-61
FD
Outputs the most recent measured/computed data
Operation mode Y
es Yes 3-61
FF
Outputs FIFO data
Operation mode Y
es Yes 3-61
FL
Outputs a log, alarm summary
, or message summary All modes
Yes Yes 3-62
IS
Outputs status information
All modes Y
es Yes 3-62
FU
Outputs user levels
All modes Y
es Yes 3-63
FA
Outputs internal DX information
All modes Y
es Yes 3-63
ME
Outputs data stored on the external storage medium
Operation mode Y
es No 3-63
and internal memory
MO
Outputs the data stored in the internal memory
. Operation mode
Yes No 3-63
Dedicated commands for RS-422/485
Esc
O
Opens an instrument
All modes Yes Yes 3-64
Esc C
Closes an instrument
All modes Yes Yes 3-64
Common commands among instruments
*I
Outputs instrument information
All modes Y
es Yes 3-65
Maintenance/Test Commands (Available when using the maintenance/test
server function via Ethernet communications)
Command Function Administrator User Page
Name
close
Closes another device’s connection Yes No 3-65
con
Outputs connection information Yes
Yes 3-65
eth
Outputs Ethernet statistics Yes
Yes 3-65
help
Outputs help Y
es Yes 3-66
net
Outputs network statistics Yes
Yes 3-66
quit
Closes the connection to the instrument that you are operating Y
es Yes 3-66
Instrument Information Output Commands (Available when using the
instrument information server function via Ethernet communications)
Parameter Function Page
Name
serial
Outputs the serial number 3-67
host
Outputs the host name 3-67
ip
Outputs the IP address
3-67
3.2 A List of Commands