User Manual

IM 04P01B01-01E
7-40
7.24 Enabling Start Printout, End printout, and
Message Format (/BT1 Option)
This section explains the details of enabling/disabling the Start printout, End printout, and
Message format.
Basic Setting mode cannot be entered when recording is in progress or when
computation is in progress on models with the computation function (/M1 option).
Procedure
Changing the Settings
1.
Hold down the
MENU
key for 3 seconds to enter Setting mode.
2.
Hold down the and keys simultaneously for 3 seconds to enter Basic
Setting mode.
3.
Press the key or SHIFT + key to select Batch and then press the
key.
4.
Set each item and press the key.
Use the
key or SHIFT + key to select values.
For the procedure on how to enter values or characters, see section 4.2.
If you press the ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
5.
When the Setting complete screen appears, do either of the following:
To correct the setting the
key.
If you are done, press the ESC key.
Basic=Batch
Dual comment=Use
Basic batch
Setting complete
Enable/disable the Start printout and
End printout function.
Select 4 or 6 digits for the number of
digits in the lot number, or disable.
Select to enable or disable Start
printout 2 and End printout 2.
The new setting takes effect.
MSG format=Use
Enable/disable the message format
function.
ESC/?
Batch=Use
(Only when batch is set to Use)
(Only when batch is set to Use)
Lot No.=4
Applying the Changes and Returning to Operation Mode
Press the key or SHIFT + key to select End and then press the key. Press
the
key to select Store and then press the key. The changes are applied, and
the screen returns to Operation mode. If you select Abort and press the
key, the
changes are discarded, and the screen returns to Operation mode. Press the ESC key to
return to the Bas
ic=
screen.