User Manual
vi
IM 04P01B01-17E
Names of Parts and Basic Key Operations
Basic Key Operations
This section describes basic operations on the front panel keys to change various
settings.
• Execution Modes
The recorder has the following execution modes.
• Operation mode: A mode used to perform recording and monitoring.
•
Setting
mode
: A mode used to set the input range, alarms, chart speed, and other
parameters.
• Basic Setting mode: A mode used to set the basic specications of functions with
the recording operation stopped.
* In the explanation of commands in (chapter 4), Run mode collectively refers to Operation
mode and Setting mode.
Settings related to communications are congured in Basic Setting mode. You cannot
enter Basic Setting mode while the recorder is recording or while computation is in
progress on the computation function (/M1 option).
• Entering Basic Setting Mode
Hold down the
MENU
key for 3 seconds.
The Setting mode display appears.
Set=Range
Input range and s
The panel keys are set to the functions marked above the keys as shown below.
RCD
MENU FEED
CH UP
FUNC
MENU
DISP
1
CHARACTER ESC/? SHIFT
Hold down both the (
DISP
) key and the (
FUNC
) key for 3 seconds.
The Basic Setting mode display appears. The top and bottom lines are the setup item
and comment, respectively. The section that is blinking in the setup item that you
change. In this manual, the section that you change appears shaded.
The comment line shows useful information such as a descrip
tion of the setup item
and the range of selectable values. Read the comment and change the items as
necessary.
The item to be controlled blinks.
Setup item
Comment
Basic=Alarm
Auxiliary alarm
• Selecting the Setup Item and Value
The selected item change each time you press the (
DISP
) key. The selected item
change in reverse order if you press the
(
DISP
) while holding down the SHIFT
(
FEED
) key.
Selections
Basic=Ethernet
This manual denotes the operation of pressing a key while holding down the SHIFT
(
FEED
) key as SHIFT + the other key (for example: SHIFT + key).
After you make a selection, press the
(
CH UP
) key. The next screen appears. When
the Setting Complete
screen appears, the changed item is applied.
Ethernet host
Setting complete
• Using the ESC Key
If you press the ESC (
MENU
1
) key, the operation is cancelled, and the display returns
to a higher level menu. If you do not show the Setting Complete screen, the changes
you made up to that point are discarded.
You can show and hide the comment on the bottom line by pressing the ESC
(
MENU
1
)
key while holding down the SHIFT (
FEED
) key.