User Manual

IM 04P01B01-02E

Common Operations and Menu Structure

Execution Modes

The recorder has three execution modes.

Operation Mode

This mode is used for normal recording operation. The recorder enters this mode when

the power is turned ON.

Setting Mode

This mode is used to set the input range, alarms, chart speed, and other parameters.

These settings can be changed while recording is in progress. However, the input

range of measurement channels and the computing equation, unit, constant, and TLOG

setting of computation channels cannot be changed while computation (/M1 option) is in

progress.

Basic Setting mode

This mode is used to set the basic specifications of the recorder such as the

thermocouple burnout detection function and the alarm output relay operation. This mode

cannot be entered while the recorder is recording or while computation is in progress

on the computation function (/M1 option). Measurement, recording, and alarm detection

cannot be carried out in this mode.

Operation mode

Power ON

Setting mode

Data display setup screen

Basic Setting mode

Display “End=Store” and press

Hold down

for 3 s

Hold down

for 3 s

Data display screen

Operation Sequence

This section explains the operations that need to be carried out when using the recorder

for the first time.

• Preparing to Record

Load the chart paper and pens (pen model) or ribbon cassette (dot model). Change

the date/time if necessary.

For the operating procedure, see page 27.

• Setting the Channel Input Range and Other Parameters

Set the measurement conditions suitable for the object being measured.

This manual explains the following operations.

• Setting the input range and alarm (see page 33 for the procedure)

• Changing the chart speed (see page 42 for the procedure)

• Recording/Displaying Data

Start/Stop the recording operation and carry out various types of printouts. Also,

switch the display screen and change the displayed contents.

For the operating procedure, see page 41.