Owner's manual

IM 12B06K07-E-E
6. Parameterization
There is the risk of damaging the system or
that process fluid or cleaning solution issues
in an uncontrolled manner!
• Wear suitable protective clothing
• Have the system only parameterized by instructed
skilled personnel!
• Inspect all sealings and all connections of the
fitting prior to running the process
Wear protective glasses and protective
clothing when you start the system!
The control is generally operated as follows:
Main Menu
Automatic Mode
Manual Mode
Parameter
System
UP DOWN
• The upper line shows the current menu.
• The lower line shows the functions of the soft keys.
• The function which can be selected is shown
invertedly in the respective case and selected by
means of the Enter button.
• The ESC button brings you back one menu each
time.
6.1 Main Menu
In the Main Menu, you can choose between the
individual processes.
Main Menu
Automatic Mode
Manual Mode
Parameter
System
UP DOWN
• When you select the Automatic Mode, the
parameterized automatic process in the control
starts (see chapter 6.2).
• When you select the Manual Mode, you reach the
level for manual operation (see chapter 6.3).
• When you select Parameters, you reach the
parameterization (see chapter 6.4).
• When you select System, you reach the system
control (see chapter 6.5).
6.2 Automatic Mode
The parameterized process runs in automatic mode
and the display shows the following:
Automatic 12:22:17
* Measuring *
In 45 Min. Service
Info Para Stop
• The first line shows Automatic and the current
time in HH:MM:SS.
• The middle shows the current function in big
letters.
• Below, the time remaining until the next function
or action starts is shown.
• The soft keys are assigned to the following
parameters:
Info Para Stop
Info Shows information relating to the control
via preset times, the total time of a cleaning
cycle and the state of the software.
Para Leads you to the parameterization of the
cleaning and interval times (chapter 6.4).
Stop Automatic can be interrupted here.
By pressing the stop button, you can select
between an Emergency Stop and a “gentle”
Stop.
In case of an Emergency Stop, the fitting
immediately moves to the service position,
stays there and is not rinsed.
In case of stop, the fitting moves to
the service position and finishes with a
parameterized rinsing process.
CAUTION!
DANGER!
WARNING!
CAUTION!
DANGER!
WARNING!