Instruction Manual

IM 11M12D01-61E

<1. INTRODUCTION>

1-2

- Use of the product in question in a location not conforming to the standards specied by

Yokogawa, or due to improper maintenance of the installation location.

- Failure or damage due to modication or repair by any party except Yokogawa or an

approved representative of Yokogawa.

- Malfunction or damage from improper relocation of the product in question after delivery.

- Reason of force majeure such as res, earthquakes, storms/oods, thunder/lightening, or

other natural disasters, or disturbances, riots, warfare, or radioactive contamination.

In wiring, please conrm voltages between the power supply and the instrument before

connecting the power cables. And also, please conrm that the cables are not powered before

connecting.

n Safe Use of This Product

For the safety of the operator and to protect the instrument and the system, please be sure to

follow this manual’s safety instructions when handling this instrument. If these instructions are not

heeded, the protection provided by this instrument may be impaired. In this case, Yokogawa

cannot guarantee that the instrument can be safely operated. Please pay special attention to the

following points:

(a) Installation

• This instrument may only be installed by an engineer or technician who has an expert

knowledge of this device. Operators are not allowed to carry out installation unless they

meet this condition.

• When removing the instrument from a hazardous process, avoid contact with the uid and

the interior of the meter.

• All installation work shall comply with local installation requirements and the local electrical

code.

(b) Wiring

• The instrument must be installed by an engineer or technician who has an expert knowledge

of this instrument. Operators are not permitted to carry out wiring unless they meet this

condition.

• Before connecting the power cables, please conrm that there is no current owing through

the cables and that the power supply to the instrument is switched off.

• Please carry out only the maintenance procedures described in this manual. If you require

further assistance, please contact the nearest Yokogawa ofce.

• Care should be taken to prevent the build up of dust or other materials on the display glass

and the name plate. To clean these surfaces, use a soft, dry cloth.

(d) Modication

• Yokogawa will not be liable for malfunctions or damage resulting from any modication

made to this instrument by the customer.

WARNING