Instruction Manual

<APPENDIX 1. LIST OF PARAMETERS FOR EACH BLOCK OF AV550G>
A-8
IM 11M12D01-61E
65 2065 CH2_TC_VOLT – – Denotes the thermocouple electromotive force of the
channel-2 detector.
66 2066 CH2_CJ_VOLT – – Denotes the cold junction voltage of the channel-2 detector.
67 2067 CH2_CELL_RESISTANC
E
– – Denotes the cell resistance of the channel-2 detector
measured during calibration.
68 2068 CH2_CJ_RESISTANCE – – Denotes the cold junction resistance of the channel-2 detector.
69 2069 CH2_ZERO_CAL_COEFF – – Denotes the zero-point correction factor of the channel-2
detector.
70 2070 CH2_SPAN_CAL_COEFF – – Denotes the span-point correction factor of the channel-2
detector.
71 2071 CH2_CELL_ROBUSTNES
S
– – Denotes the cell service life of the channel-2 detector.
72 2072 CH2_HEATER_ON_TIME – – Denotes the power-on rate of the channel-2 detector’s heater.
73 2073 CH2_RESPONSE_TIME – – Denotes the response time of the channel-2 detector
measured during calibration.
74 2074 CH2_MIN_VALUE – – Denotes the minimum oxygen concentration of channel 2.
75 2075 CH2_MAX_VALUE – – Denotes the maximum oxygen concentration of channel 2.
76 2076 CH2_AVE_VALUE – – Denotes the average oxygen concentration of channel 2.
77 2077 CH2_MIN_DATE – – Denotes the date and time when the minimum oxygen
concentration of channel 2 was calculated.
78 2078 CH2_MAX_DATE – – Denotes the date and time when the maximum oxygen
concentration of channel 2 was calculated.
AppendixA1-3_3.ai
79 2079 CH3_CELL_VOLT – – Denotes the cell electromotive force of the channel-3 detector.
80 2080 CH3_HEATER_TEMP – – Denotes the heater temperature of the channel-3 detector.
81 2081 CH3_CJ_TEMP – – Denotes the cold junction temperature of the channel-3
detector.
82 2082 CH3_TC_VOLT – – Denotes the thermocouple electromotive force of the
channel-3 detector.
83 2083 CH3_CJ_VOLT – – Denotes the cold junction voltage of the channel-3 detector.
84 2084 CH3_CELL_RESISTANC
E
– – Denotes the cell resistance of the channel-3 detector
measured during calibration.
85 2085 CH3_CJ_RESISTANCE – – Denotes the cold junction resistance of the channel-3 detector.
86 2086 CH3_ZERO_CAL_COEFF – – Denotes the zero-point correction factor of the channel-3
detector.
87 2087 CH3_SPAN_CAL_COEFF – – Denotes the span-point correction factor of the channel-3
detector.
88 2088 CH3_CELL_ROBUSTNES
S
– – Denotes the cell service life of the channel-3 detector.
89 2089 CH3_HEATER_ON_TIME – – Denotes the power-on rate of the channel-3 detector’s heater.
90 2090 CH3_RESPONSE_TIME – – Denotes the response time of the channel-3 detector
measured during calibration.
91 2091 CH3_MIN_VALUE – – Denotes the minimum oxygen concentration of channel 3.
92 2092 CH3_MAX_VALUE – – Denotes the maximum oxygen concentration of channel 3.
93 2093 CH3_AVE_VALUE – – Denotes the average oxygen concentration of channel 3.
94 2094 CH3_MIN_DATE – – Denotes the date and time when the minimum oxygen
concentration of channel 3 was calculated.
95 2095 CH3_MAX_DATE – – Denotes the date and time when the maximum oxygen
concentration of channel 3 was calculated.
96 2096 CH4_CELL_VOLT – – Denotes the cell electromotive force of the channel-4 detector.
97 2097 CH4_HEATER_TEMP – – Denotes the heater temperature of the channel-4 detector.
98 2098 CH4_CJ_TEMP – – Denotes the cold junction temperature of the channel-4
detector.
99 2099 CH4_TC_VOLT – – Denotes the thermocouple electromotive force of the
channel-4 detector.
100 2100 CH4_CJ_VOLT – – Denotes the cold junction voltage of the channel-4 detector.