Manual

<7. Inspection and Maintenance>
7-8
IM 11M10B01-01E
7.5 How to Replace the Line Filter
The line lter is inside the gas inlet connector on the rear panel. The line lter is covered by a plate,
and both these parts are held in place by a C-shaped snap ring. The following explains how to replace
the line lter. This requires a pair of snap ring pliers and some tweezers.
1) Insert the tips of the snap ring pliers in the holes on the snap ring and apply pressure to release
and remove the snap ring.
2) With the tweezers, remove rst the plate and then the lter.
3) Attach the new lter, plate, and snap ring in this order.
• Insert the lter into the connector with the smooth side facing up.
• Place the plate over it with the ne mesh side facing down.
• With the snap ring pliers, apply pressure to insert the snap ring, and hold down and secure the
lter and plate in place with the snap ring. At this point, make sure you attach the snap ring rmly
in place so that the plate is secured enough that it cannot be moved even if an attempt to move it
with tweezers is made.
CAUTION
The snap ring must be securely attached to rmly hold the lter and plate in place. Otherwise, the lter
will not function correctly.
Gas Inlet
Filter
(K9643FB)
The smooth side facing up
The fine mesh side facing down
Plate
(K9213FB)
C-shaped snap ring
(Y9011EV)
Up
Dwon
Figure 7.6 How to Replace the Line Filter