Manual

<7.InspectionandMaintenance>
7-4
IM 11M10B01-01E
5) Remove the lead wire connector of the sensor from the PCB board.
6) Loosenthejointring
1
on the sensor outlet side and remove it towards the heater side.
7) Pulloutthejoint
2
while holding the sensor.
8) Rotatetheinlet-sidejointnut
3
counter clockwise seen from the heater side and remove it.
O-ring
Sensor
Lead wire connector
Lead wire connector
Heater
Heater
1
1
2
2
3
3
9) Pull out the holding plate
4
,
remove the ring
1
, and pull the sensor out of the heater
straightforward.
O-ring
Lead wire connector
Heater
1
2
3
4
Figure7.2 RemovingSensor