User Manual

IM 11M13A01-04E

7-6

7.4.3 Entering Parameter Code Selection Display

This section briefly describes the password entry procedure for entering the parameter

code selection display. The password is 1102 - it cannot be changed to a different

password.

Table7.3 Parameter Code Selection

Switch operation Display Description

. ENT

T7.4.3E.EPS

The symbol [ ] indicates that the key is being touched.

Light characters indicates that the digits are flashing.

21.0%

PASSno

0000

1000

1100

1102

A01

Warm-up is complete, and the basic panel is now displayed.

Continuously touch the [ENT] key for at least three seconds

to display "PASSno."

Touch the [ENT] key again. This allows you to change the leftmost

digit that is flashing.

Set the password 1102. If you touch the [ ] key, the digit that is flashing

will be 1.

Touch the [>] key to move the position of the digit that is flashing to the

right one digit.

Touch the [ ] key to change the numeric value to 1.

Touch the [>] key again to move the position of the digit that is flashing

to the right one more digit. Continuously touch the [>] key, and the position

of the digit that is flashing will move continuously to the right.

Touch the [ ] key to change the numeric value to 2. Continuously touch

[>] key, and the numeric value increases continuously

If you touch the [ENT] key, all the digits flash.

Touch the [ENT] key again to display A01 on the parameter-code selection

display.

CAUTION

• If no key is touched for at least 20 seconds during password entry, the current display

will automatically switch to the basic panel display.

• If no key is touched for at least 10 minutes during parameter code selection, the

current display will automatically switch to the basic panel display.