Owner's manual

<8. Detailed Data Setting>
8-10
IM 11M12A01-04E
8.5.3 Default Values
When the analyzer is delivered, or if data are initialized, output contacts are by default as shown in
Table 8.11.
Table 8.11 Output Contact Default Settings
Item Output contact 1 Output contact 2
High-high alarm
High alarm
Low alarm
Low-low alarm
Error O
Warm-up O
Output range change
Calibration
Maintenance O
High limit temperature alarm
Calibration gas pressure decrease
Unburnt gas detection
Operating contact status Open Closed (xed)
O: Present
NOTE
The above blank boxes indicate the items have been set off.