Owner manual

IM 11M12A01-05E
8-18
8.6 Input Contact Settings
8.6.1 Setting Input Contact
The following describe how to set the date-and-time. Automatic calibration works
following this setting.
Use parameter code “F10” to set the date-and-time.
Table 8.13 Data-and-time Settings
T8.14E.EPS
``ENT
F10
> ` ENT
00.01.01
> ` ENT
00.01.01
> ` ENT
00.06.01
> ` ENT
00.06.01
> ` ENT
00.06.21
> ` ENT
00.06.21
> ` ENT
07.18
> ` ENT
14.30
> ` ENT
14.30
> ` ENT
14.30
> ` ENT
F10
Select the parameter code "F10."
If you touch the [ENT] key, the current date will be displayed. The display
on the left indicates the date - January 1, 2000. To set June 21, 2000, follow
the steps below:
Touch the [
>] to move the position of the digit that is flashing to the right.
Touch the [`] key to change to 6.
Touch the [>] key to move the position of the digit that is flashing to the
right one digit.
Touch the [`] to change to 2.
Touch the [>] key to move the position of the digit that is flashing to the
right one digit.
Let the rightmost character flash, and touch the [>] key to display the time.
Continuously touch the [>] key, then the date and time are alternately
displayed. Displayed on the left is 7:18 a.m.
Omitted here.
Touch the keys and enter the current time in same way as the date has
been entered, on a 24-hour basis. 2:30 p.m. Displayed on the left means 2:40 p.m.
If you touch the [ENT] key, all the digits flash.
Touch the [ENT] key again to set the time.
If you touch the [
>] and [ENT] keys together, the parameter code selection display
appears.
Switch operations
Display
Brief description
The symbol ( ) indicates that the key is being touched. Light characters indicate that the digits are flashing.