Owner manual

IM 11M12A01-05E
8-11
8. Detailed Data Setting
8.3.3 Alarm Setting Procedure
Set the alarm setpoints following Table 8.6 listing parameter codes.
Table 8.6 Alarm Parameter Codes
T8.3.3.1.EPS
Set item Parameter code Set value
Oxygen concentration high-high alarm setpoint D01 0-100% O
2
Oxygen concentration high-alarm setpoint D02 0-100% O
2
Oxygen concentration low-alarm setpoint D03 0-100% O
2
Oxygen concentration low-low-alarm setpoint D04 0-100% O
2
Humidity high-high alarm setpoint D05 0-100% H
2
O
Humidity high-alarm setpoint D06 0-100% H
2
O
Humidity low-alarm setpoint D07 0-100% H
2
O
Humidity low-low-alarm setpoint D08 0-100% H
2
O
Mixing ratio high-high alarm setpoint D11 0-1 kg/kg
Mixing ratio high-alarm setpoint D12 0-1 kg/kg
Mixing ratio low-alarm setpoint D13 0-1 kg/kg
Mixing ratio low-low-alarm setpoint D14 0-1 kg/kg
Oxygen concentration alarm hysteresis D30 0-9.9% O
2
Humidity hysteresis D31 0-9.9% H
2
O
Mixing ratio hysteresis D32 0-0.1 kg/kg
Delay alarm action D33 0-255 seconds
Oxygen concentration high-high alarm detection D41 0: Not detected
1: Detected
Oxygen concentration high-alarm detection D42 0: Not detected
1: Detected
Oxygen concentration low-alarm detection D43 0: Not detected
1: Detected
Oxygen concentration low-low-alarm detection D44 0: Not detected
1: Detected
Humidity high-high alarm detection D45 0: Not detected
1: Detected
Humidity high-alarm detection D46 0: Not detected
1: Detected
Humidity low-alarm detection D47 0: Not detected
1: Detected
Humidity low-low-alarm detection D48 0: Not detected
1: Detected
Mixing ratio high-high alarm detection D51 0: Not detected
1: Detected
Mixing ratio high-alarm detection D52 0: Not detected
1: Detected
Mixing ratio low-alarm detection D53 0: Note detected
1: Detected
Mixing ratio low-low-alarm detection D54 0: Not detected
1: Detected
CAUTION
Even with alarms set, if “Not detected” has been set in the above alarm detection, no
alarm is issued. Be sure to set “Detected” in the above alarm detection if you use alarm
features.